ASME Shop Inspection Request

It may take up to 5 business days from time of receiving all supporting documentation for confined space entry and pneumatic testing (where applicable) to process the inspection request. Incomplete documentation may delay the inspection.

Should an Authorized Inspector (AI) attend a site where there are unsafe conditions for the AI, the inspection may be cancelled and cancellation fees would be applied.

Will the inspection involve confined space entry?

Yes

Important

Complete the Confined Space Entry Client and Technical Safety BC Verification Checklist and submit the Checklist with the following three documents as described in the Checklist. If you have further questions, refer to the information found on Confined Space Entry Requirements.

1. Hazard Assessment

One file only.
256 MB limit.
Allowed types: txt, rtf, pdf, doc, docx, odt, ppt, pptx, odp, xls, xlsx, ods.

2. Confined Space Entry (CSE) Procedures

One file only.
256 MB limit.
Allowed types: txt, rtf, pdf, doc, docx, odt, ppt, pptx, odp, xls, xlsx, ods.

3. CSE Rescue Procedures

One file only.
256 MB limit.
Allowed types: txt, rtf, pdf, doc, docx, odt, ppt, pptx, odp, xls, xlsx, ods.

Will the inspection involve pneumatic testing?

Yes

Your safety officer must review and accept a pneumatic test procedure before a pneumatic test over 15 psig but equal to or less than 1677 kJ. If the pneumatic test is over 1677 kJ, an Application-specific procedure must be developed. The Application-specific procedure shall be developed and approved by a Professional Engineer.

Is the pneumatic testing over 1677 kJ?

Yes

Upload the pneumatic test procedure (equal to or less than 1677 kJ)

One file only.
256 MB limit.
Allowed types: txt, rtf, pdf, doc, docx, odt, ppt, pptx, odp, xls, xlsx, ods.

The Application-specific procedure (greater than 1677 kJ) must be forwarded to boiler.designregistration@technicalsafetybc.ca to be reviewed and approved by Design Survey Engineering before an inspection request can be submitted. For information refer to Pneumatic Testing.

Will the inspection involve proof testing?

Yes

Review the Proof Testing letter, found here.

Requested Inspection Date and Time

Reminder: all inspection requests received after 3 pm, Monday to Friday, will be treated as a request submitted on the next business day.

Shop Name

Job Identification Number

Expected Duration (hours)

Address / Location of Inspection

Address

Address 2

City/Town

Postal Code

Equipment to be Inspected

Inspection Parameters

Special Instructions

Requestor

Name

Phone

Submission Date

Note: Technical Safety BC collects your personal information for the purpose of administering permits and other activities under the Safety Standards Act and may need to disclose this information to entities such as utilities, provincial agencies and municipalities.

By submitting this form you are consenting to the disclosure described above. Any personal information collected is handled in accordance with the British Columbia Freedom and Protection of Privacy Act.

If you have questions about the collection, use, or disclosure of this information, contact the Records, Information and Privacy Analyst at Technical Safety BC.

Payment Card Industry Data Security Standards prevent the use of credit card information sent through email or fax. A Client Service Representative will contact you within three business days to complete any payment process required.

FRM-1552-00 (2017-01-18)

ASME Shop Inspection Request

Important

Footer